Momentive RTV106

High-Temperature Moisture Cure Single Component Silicone Paste RTV Adhesive Sealant, Red

In Stock

RTV100 Series one-component, ready-to-use adhesive sealants are extremely versatile. They cure to a tough, durable, resilient silicone rubber on exposure to atmospheric moisture at room temperature. Acetic acid vapors are released from the sealant surface as a by-product of cure. RTV106 sealant is paste-consistency sealant. It is a standard-strength high-temperature sealant.

One-component products
Capability to cure at room temperature and ambient humidity
Self-adhesion properties
Low-temperature flexibility
High-temperature performance
Excellent weather ability and oz.one and chemical resistance
Excellent electrical insulation properties

Tan bajo como USD 782.16

Saltar al final de la galería de imágenes

Saltar al comienzo de la galería de imágenes

Documentos técnicos

SDS/MSDS Sheets

Momentive RTV106 Safety Data Sheet

Detalles

Más información
Código PAC	C100321
Modelo del fabricante	RTV106
Marca	Momentive

Más información

Since all these sealants utilize a moisture cure system, they must not be used in thicknesses of greater than 6mm (1/4 in.). Where section depths exceed 6mm (1/4 in.), Momentive Performance Materials one component, additional cure, or two-component silicone rubber compounds are recommended.

Uncured Properties
Consistency	Paste
Color	RTV106: Red
Application Rate, (g/min)	400
Specific Gravity	1.05
Tack-Free Time, minutes	20
Cured Properties⁽¹⁾
Mechanical:
Tensile Strength, kg/cm² (lb/in²)	28 (400)
Elongation, %	450
Hardness, Shore A	30
Tear Strength, kg/cm (lb/in)	8 (45)
Shear Strength, kg/cm² (lb/in²)⁽²⁾	14 (200)
Peel Strength, kg/cm (lb/in)(3)	7 (40)
Electrical:
Dielectric Strength, kv/mm (v/mil)	20 (500)
Dielectric Constant @ 60 Hz	2.8
Dissipation Factor @ 60 Hz	0.001
Volume Resistivity, ohm-cm	3 x 10¹⁵
Thermal:⁽⁴⁾
Brittle Point, °C (°F)	-60 (-75)
Maximum continuous operating temperature, °C (°F)	204 (400)
Maximum intermittent operating temperature, °C (°F)	260 (500)
Additional Information:⁽⁴⁾
Thermal Conductivity, cal/sec/cm², °C/cm (Btu/hr/ft², °F/ft)	0.0005 (0.12)
Coefficient of Expansion, cm/cm, °C (in/in, °F)	27 x 10^-5 (15 x 10^-5)

(1) Cure time 3 days at 25°C (77°F) / 50% relative humidity.
(2) At 100% cohesive failure.
(3) At 100% cohesive failure using 1 in. x 8 in. stainless steel screen at 180° pull angle.
(4) Information is provided for customer convenience only. These properties are not tested on a routine basis.