910FS Metal Bonding Wicking Grade Cyanoacrylate Adhesive, Clear

Physical Properties of Uncured Adhesive

• Chemical composition: Methyl cyanoacrylate
• Appearance: Colourless
• Viscosity @ 25°C: 2-4 mPa.s (cP)
• Specific gravity: 1.1

Typical Curing Properties

• Maximum gap fill: 0.05mm (0.002")
• Fixture/handling time* (0.3 N/mm² shear strength is achieved)
  
  • <5 seconds (Steel)
  • <10 seconds (Buna N Rubber)
  • <10 seconds (Phenolic)
• Full strength 24 hours

*Handling times can be affected by temperature, humidity, and specific surfaces being bonded. Larger gaps or acidic surfaces will also reduce cure speed but this can be overcome by the use of Permabond C Surface Activator (CSA) or Permabond QFS 16.

Typical Performance of Cured Adhesive

• Shear strength* (ISO4587):
  • Steel 23-29 N/mm² (3300-4200psi)
  • Aluminium 13-15 N/mm² (1900-2200psi)
  • Brass 21 N/mm² (3000psi)
  • Stainless Steel 21 N/mm² (3000psi)
  • Butyl Rubber >2 N/mm² (300psi) SF**
  • Nitrile Rubber >4 N/mm² (600psi) SF**
  • Phenolic >9 N/mm² (1450psi) SF**
  • ABS >9 N/mm² (1300psi) SF**
  • Acrylic >14 N/mm² (2000psi) SF**
  • PVC >6 N/mm² (870psi) SF**
  • Polycarbonate >6 N/mm² (870psi) SF**
• Impact strength (ASTM D-950): 3-5 kJ/m² (1.4-2.4 ft-lb/in²)
• Dielectric constant @10kHz: 2.5
• Dielectric strength: 25 kV/mm
• Coefficient of thermal expansion: 90 x 10^-6mm/mm/°C
• Coefficient of thermal conductivity: 0.1 W/(m.K)
• Hardness (ISO868): 85 Shore D

*Strength results will vary depending on the level of surface preparation and gap.
**SF = Substrate failure