WickGun™ Desoldering Braid Dispenser

To load the WickGun™ dispenser, follow these steps:

1. Grasp cassette and pull out foam plug, then pull out approximately 2-1/4" (57 mm) of wick.
2. Insert wick into guide slot. Rotate drive knob in feed direction while seating cassette. Ensure wick is not pinched between cassette and WickGun™ and that cassette alignment tabs are seated in the alignment slots in the gun.
3. If wick fails to feed, disengage cassette, grasp wick and pull from wick guide slot, do not allow cassette to unwind. Eliminate any kinks and/or frayed wick. Repeat steps 1-2.

To operate the WickGun™ dispenser, follow these steps:

1. Hold with thumb on drive knob and index finger over the trigger.
2. Rotate drive knob in feed direction exposing 3/4" to 1" (19 to 25 mm) of wick. Do not press on the trigger while dispensing wick.
3. Perform desoldering operation.
4. Squeeze trigger to cut off filled wick.